Embedded 4/8/16-CH Instrukcja Użytkownika Strona 25

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 53
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 24
4/8/16-channel H.264 DVR User Manual
21
3.7.1 Alarm
Move the cursor to the “Alarm” option (the icon is surrounded by a yellow frame to
indicate selection), and press “Enter” to enter the setup screen of this option, as shown
below:
I/O CHANNEL/ALARM: Each channel corresponds to an I/O state alarm, when the
alarm input of a channel is valid, the alarm record of the corresponding channel will be
started.
Normal On: The external alarm circuit is open at ordinary times, and closed when
there is an alarm.
Normal Off: The external alarm circuit is closed at ordinary times, and open when
there is an alarm.
Note: When an alarm is produced, a red letter “I” will be displayed above the
corresponding channel.
HDD LOSS: On: When the system cannot identify the hard disk, an alarm will be
generated, and a red mark “H” will be displayed at the bottom left corner of Channel 1
in the lower part of the Video Preview screen.
HDD SPACE: On: When the remaining space of the hard disk is less than 500M, the
lower part of the Video Preview screen will display: “The space of the hard disk is not
enough. Please change the disk after shutdown.”
VIDEO LOSS: On: When the video of a certain channel is lost, this channel will display
in the lower part of the Video Preview screen: “Video Loss”.
ALARM MANAGE OUTPUT
: the time of the DVR outputting the alarm signal to
the outside when an alarm is generated, with the options of 0sec, 10sec, 20sec,
40sec and 60sec
BUZZER: the time of buzzer ringing when an alarm is generated, with the options of
0sec, 10sec, 20sec, 40sec and 60sec
Post Alarm Recording: the time of record delay after the motion detection alarm,
with the options of 30sec, 1min, 2min and 5min
Email SETUP: This unit supports motion detection and e-mail alarm.
Email setup Prerequisite: The mainframe must be connected to the WAN. See Chapter
4 “DVR Network” for the connection method.
When motion detection is triggered, the system will extract a picture at the time of
triggering and send it to the corresponding mailbox. The size of the extracted picture is
about 11K.
Przeglądanie stron 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 52 53

Komentarze do niniejszej Instrukcji

Brak uwag